NEWS CATEGORIES

18 meter truss bridge inspection car rental bridge inspection car rental

Data：2020/9/17 14:27:09

18 meter truss bridge inspection car rental bridge inspection car rental bridge inspection car hire Xinyue road and Bridge Consulting Hotline: 1830208001 If there is no problem with flatness, the width of slotting shall be determined according to the requirements of construction drawings, accurate setting out, cutting machine shall be used to cut the seam, and the asphalt concrete pavement outside the SAW seam line shall be protected by pasting adhesive tape or covered with plastic cloth, so as to prevent stone powder generated during sawing from polluting the pavement. Saw joints shall be neat and straight. After cutting the joint, the stone powder should be cleaned with clear water immediately. The 18 meter truss bridge inspection car rents the fresh bridge inspection car to rent the bridge inspection car. The consultation hotline of Xinyue road and bridge is 18302080001. If the seam is cut directly by dry cutting, that is, without adding water, it should be blown with a blower immediately. Otherwise, it will be difficult to clean after it dries out (in case of water), causing road pollution. In order to make the expansion joint beautiful and straight in the future, the secondary cutting joint can be used. The width of the secondary cutting joint is not enough, and 5cm is reserved on both sides. After the expansion joint is installed and before the concrete of the expansion joint is poured, the 5cm can be cut off. The purpose is to prevent the damage of the edge part when the expansion joint is placed, resulting in the truss bridge detection car with the joint of not more than 18 meters to rent

{Lankecms_eprev} {Lankecms_enext}